NI PXI-1033電纜組
1.產 品 介 紹
品牌:NI
型號說明:NI PXI-1033電纜組
優勢:供應進口原裝正品,專業停產配件。
公司主營特點:主營產品各種模塊/卡件,控制器,觸摸屏,伺服驅動器。
2.產 品 詳 情 資 料:
將以太網雙絞線電纜連接到基板上的COM1連接器(COM2不用于連接到INSUM)。3.通過以太網/LON網關將以太網電纜的另一端連接到INSUM設備。以太網雙絞線連接以太網雙絞線通過位于NI PXI-1033上的10BaseT RJ45連接器連接。有關連接器的說明,請參見第84頁的表5。請注意,CI857單元沒有單元冗余。請安裝DriveBus接口NI PXI-1033。NI PXI-1033由處理器單元通過CEX總線供電,因此不需要額外的外部電源。該裝置安裝在水平DIN導軌上。將裝置安裝到DIN導軌上,請參見第65頁將AC 800M裝置安裝到DINRail上,第78頁將PM86x/TP830處理器裝置安裝到單配置中,第313頁將NI PXI-1033安裝到DriveBus接口上。光學連接器CI858板通過三對光學接收器/發射器連接到驅動系統。使用HP/Agilent Technologies Versatile Link系列(HFBR系列)光學發射器/接收器。光纖的傳輸速度為4Mbit/s。NI PXI-1033
Connect the Ethernet twisted pair cable to the COM1 connector on the baseplate (COM2 is not used for connection to INSUM). 3. Connect the other end of the Ethernet cable to the INSUM equipment via Ethernet/LON Gateway. Ethernet Twisted Pair Connection The Ethernet twisted pair is connected via the 10BaseT RJ45 connector located on TP853. For a description of the connector see Table 5 on page 84. Note that there is no unit redundancy for the CI857 unit.nstalling the DriveBus Interface, NI PXI-1033The NI PXI-1033is powered from the processor unit via the CEX bus and requires therefore no additional external power source. The unit is mounted onto a horizontal DIN rail. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65, Installing the NI PXI-10330 Processor Unit in Single Configuration on page 78 and CI858 and NI PXI-1033 – DriveBus Interface on page 313. Optical Connectors TheNI PXI-1033 board connects to the drive system via three optical receiver/transmitter pairs. HP/Agilent Technologies Versatile Link Series (HFBR family) optical transmitter/receivers are used. Transmission speed of the optical fibres is 4 Mbit/s.
3.產 品 展 示
4.公 司 優 勢 主 營 產 品
5.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網,轉載請附上此鏈接:http://www.g2813.cn