WOODWARD 9907-072電源模塊
1.產 品 介 紹
品牌：WOODWARD
型號說明：WOODWARD 9907-072電源模塊
優勢：供應進口原裝正品，專業停產配件。
公司主營特點：主營產品各種模塊/卡件，控制器，觸摸屏，伺服驅動器。
2.產 品 詳 情 資 料：
WOODWARD 9907-072有關PROFIBUS DP和其他合適組件的更多信息，請訪問PROFIBUS用戶組織網站。請注意，CI851單元沒有單元冗余。不能在高完整性控制器中使用。CI851已被CI854通信接口取代。CI851僅出于傳統原因進行了描述。不可能通過熱插拔更換CI851單元，WOODWARD 9907-072也不允許在包含CI851的系統中執行固件的在線升級。安裝基金會現場總線H1接口，WOODWARD 9907-072由處理器單元通過CEX總線供電，因此不需要額外的外部電源。FF H1總線上的現場設備均不由CI852供電。連接到CI852的AC 800M控制器構成基金會現場總線連接設備。使用以下步驟安裝CI852/TP852:1。將裝置安裝到DIN導軌上，請參閱第65頁的“將AC 800M裝置安裝在DIN導軌上”和“以單一配置安裝PM86x/TP830處理器裝置”WOODWARD 9907-072
For additional information on PROFIBUS DP and other suitable components, visit the PROFIBUS User Organization web site. Note that there is no unit redundancy for the CI851 unit.WOODWARD 9907-072Cannot be used in High Integrity Controller. CI851 has been replaced by the CI854 communication interface. CI851 is only described for legacy reasons. It is not possible to change the CI851 unit via hot swap and it is not allowed to perform an online upgrade of firmware in a system containing CI851.Installing the FOUNDATION Fieldbus H1 Interface,WOODWARD 9907-072 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. No field device on the FF H1 bus is powered from the WOODWARD 9907-072. An AC 800M Controller connected to a CI852 constitutes a FOUNDATION Fieldbus linking device. Use the following procedure to install the CI852/TP852: 1. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single ConfigurationWOODWARD 9907-072
3.產 品 展 示
4.公 司 優 勢 主 營 產 品
5.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.g2813.cn
