NI PXIe-8135嵌入式控制器
1.產 品 介 紹
品牌:NI
型號:NI PXIe-8135
產品說明:嵌入式控制器
優勢:供應進口原裝正品,專業停產配件。
2.產 品 詳 情 資 料:
NI PXIe-8135當連接的調制解調器確實需要CTS信號時,使用跳線位置2和3(大多數調制解調器需要此信號)。強制RTS持續激活。默認位置1和2用于通過串行編程設備與PLC通信的大多數應用。如果與PLC通信設備旨在模擬HHP協議,則使用跳線位置2和3*有關信號要求,請參閱串行設備的文檔。電纜配置示例使用轉換器時所需的電纜配置示例可在附錄C中找到。轉換器的規格如下表所示。NI PXIe-813525針D型母超小型(轉換器端)9針、15針、,或25針(取決于串行設備上的連接器類型)D型微型內螺紋(編程設備端)產品目錄編號僅供參考。任何具有相同電氣特性的電纜均可接受。強烈建議您使用絞合線。NI PXIe-8135由于有時很難找到具有所需數量雙絞線的電纜(Belden 9309有一對額外的雙絞線),因此您最終可能會得到一條具有額外雙絞線的線纜。
Jumper positions 2 and 3 are used when the attached Modem does require the CTS signal (most modems require this signal).NI PXIe-8135Forces RTS to be continually active.Default position 1 and 2 is used for most applications communicating with the PLC via a serial programming device.Jumper positions 2 and 3 are used if the device communicating with the PLC is intended to emulate the HHP protocol. *Refer to the documentation for your serial device for signal requirements.Example of Cable Configurations Examples of cable configurations required when using the converter can be found in Appendix C. Specifications for the converter are shown in the following table.25-pin D-type Female Subminiature (converter end) 9-pin, NI PXIe-813515-pin, or 25-pin (depending on type of connector on your serial device) D-type Female Subminiature (programming device end)Catalog numbers are provided as suggestions only. Any cable having the same electrical characteristics is acceptable. It is strongly recommended that you use stranded wire. Since it is sometimes hard to find a cable with the desired number of twisted pairs (the Belden 9309 has an extra pair), you may end up with a cable with extra pairs.NI PXIe-8135
3.產 品 展 示
4.公 司 優 勢
5.關 于 我 們
本篇文章出自瑞昌明盛自動化設備有限公司官網,轉載請附上此鏈接:http://www.g2813.cn