RELIANCE 45C613通道低電平輸入模塊
閃存磁盤將配置為出廠時的單個分區設備。下面的示例序列說明了創建兩個分區的一種經過驗證的方法，其中一個分區是活動的主分區。請注意退出FDISK的說明。這已被證明是成功分區工作的重要一步。1.通電VMIVME-7740，然后進入CMOS設置。將“主控形狀”設置為“無”。將“輔助主機”設置為“自動”。將引導設備設置為軟盤。3.從軟盤啟動DOS；在啟動屏幕上，驗證Flask Disk是否顯示為Flash Disk 0。4.運行FDISK。5.刪除所有當前分區（當前存儲在分區中的任何數據都將丟失）。6.退出FDISK，這將導致重新啟動，然后再次運行FDISK。7.創建主分區。8.創建一個擴展分區，并為其設置邏輯設備。注意：如果只需要一個分區，其大小將等于閃存中可用的總可配置內存。
The Flash Disk will be configured as a single partition device as delivered from the factory. The following sample sequence illustrates a proven method for creating two partitions, with one as an active primary partition. Take note of the instructions to exit FDISK. This has been shown to be an important step in a successful partitioning effort. 1. Power up the VMIVME-7740, and enter CMOS Set-up.2. Set Primary Master to None. Set Secondary Master to Auto. Set boot device to floppy. 3. Boot DOS from the floppy; verify, on the Bootup screen, that the Flask Disk is shown as Flash Disk 0. 4. Run FDISK. 5. Delete all current partitions (any data currently stored in the partitions will be lost). 6. Exit FDISK, this will cause a reboot, then run FDISK again. 7. Create a primary partition. 8. Create an extended partition and set up a logical device for it.NOTE: If only one partition is required, its size will be equal to the total configurable memory available within the Flash Disk.
