FOXBORO FBM237 P0914XS輸出模塊
存儲鍵編程設定點時，使用和鍵輸入新值，然后按鍵。必須啟用設定點編程，以便按鍵存儲編輯值。如果新設定點成功保存在非易失性存儲器中，確認消息將閃爍。該鍵還用于添加和刪除用戶定義的默認消息。有關更多詳細信息，請參閱第9頁第3.4節：默認消息。重置鍵該鍵用于清除鎖定報警和/或輔助條件。當按下該鍵時，PQM將根據下表所示的條件執行適當?shù)牟僮?。無未采取任何措施報警報警指示燈和報警繼電器保持打開，因為條件仍然存在輔助繼電器輔助指示燈和輔助繼電器保持打開條件仍然存在
Store Key When programming setpoints, enter the new value using the and keys, followed by the key. Setpoint programming must be enabled for the key to store the edited value. An acknowledgment message will flash if the new setpoint is successfully saved in non-volatile memory. The key is also used to add and remove user defined default messages. Refer to Section 3.4: Default Messages on page –9 for further details.Reset Key The key is used to clear the latched alarm and/or auxiliary conditions. Upon pressing the key, the PQM will perform the appropriate action based on the condition present as shown in the table below.None No action taken Alarm ALARM indicators and alarm relay remain on because condition is still present Aux Relay AUXILIARY indicator(s) and aux relay(s) remain on because condition is still present Alarm and Aux Relay AUXILIARY and ALARM indicators and alarm and aux relays remain on because condition is still present
轉載請附上此鏈接：http://www.g2813.cn/
