IC695CRU320-EJ通用電氣卡件
步驟：a.區域1：當您進入?yún)^(qū)域設置時，狀態指示器D10和D14閃爍，表示區域1已準備好進行設定。將表示區域1大小的對象放置到燈光陣列的范圍中。現在按下示教按鈕以建立最高和最低中斷光束，這定義了區域1。b。區域2：狀態指示燈D11和D14在步驟a之后閃爍，這表示可以示教區域2。如步驟a所示，將一個代表區域2大小的對象放置在燈光陣列的范圍內，然后按下“示教”按鈕。c、 區域3：狀態指示燈D12和D14在步驟b后閃爍，表示區域3可以設定。再次，將一個對象放置在燈光陣列的范圍內，以表示區域3的大小，然后按下“示教”按鈕。d、 區域4：狀態指示燈D13和D14閃爍，表示可以設定區域4。將一個物體放在燈光陣列的范圍內，以表示區域4的大小，然后按下示教按鈕。狀態指示器D14現在保持打開，它確認區域的所有參數都已臨時存儲在存儲器中。6.完成示教要完成示教過程，請按住示教按鈕，直到狀態指示器D14熄滅（約5秒），這表示示教過程結束。
steps: a. Zone 1: When you enter the zone setup, status indicators D10 and D14 flash, which indicates that zone 1 is ready to be taught. Place an object that represents the size of zone 1 into the range of the light array. Now press the Teach button to establish the highest and lowest interrupted beams, which define zone 1. b. Zone 2: Status indicators D11 and D14 flash after step a, which indicates that zone 2 can be taught. As in step a, place an object that represents the size of zone 2 into the range of the light array and then press the Teach button. c. Zone 3: Status indicators D12 and D14 flash after step b, which indicates that zone 3 can be taught. Again, place an object into the range of the light array to represent the size of zone 3 and press the Teach button. d. Zone 4: Status indicators D13 and D14 flash, which indicates that zone 4 can be taught. Place an object into the range of the light array to represent the size of zone 4 and press the Teach button. Status indicator D14 now remains on, which acknowledges that all parameters for the zones have been stored temporarily in memory. 6. Complete teach To complete the teach process, press and hold the Teach button until status indicator D14 turns off (approximately 5 seconds), which signals the end of the teach process.
