GE ACC-5595-208 350-805595-208N 通用電氣卡件
如果沒有其他信息，這些DIP開關應保持在OFF位置。DIP開關8用于重置默認配置。一旦更改，DIP開關設置僅在電源循環后才能識別。表11詳細說明了I/O板的DIP開關設置。有關所列功能的更多信息，請參閱出版物10000071139。45MLA控制器的設計范圍至少為4米（13.1英尺）。因此，一些半透明目標可能無法阻擋足夠的光線，無法被正確檢測，特別是當發射器和接收器陣列放置得更近時。使用基本控制器模型，可以使用DIP開關降低發射器強度，從而更容易檢測半透明對象。根據表11，通過使用DIP開關1和2的組合，可以將發射器強度設置為全功率（默認設置）、75%的全強度功率、60%或15%。可以將基本控制器配置為忽略短光束中斷，例如通過檢測區域的小顆粒引起的中斷。可通過打開DIP開關4（并循環電源）啟用雙掃描模式。在該模式下，每個光束都會被求值兩次（而不是一次），并且只有在兩次求值期間中斷的光束才會被識別。這允許忽略短暫的光束中斷。響應時間增加。
If no information is otherwise provided these DIP switches should remain in the OFF position. DIP switch 8 is used to reset default configuration. Once changed, DIP switch settings are only recognized after a power cycle. Table 11 details DIP switch settings for the I/O board. See Publication 10000071139 for further information on the listed functions. The 45MLA controller is designed to work with a range of at least 4 m (13.1 ft). As a result some translucent targets may not block enough light to be properly detected, especially if the emitter and receiver arrays are placed closer together. With the Basic Controller model, it is possible to use DIP switches to decrease the emitter intensity, therefore making it easier to detect translucent objects. The emitter intensity may be set to full power (default setting), 75% of full intensity power, 60%, or 15% by using a combination of DIP switches 1 and 2 according to Table 11. It is possible to configure the Basic Controller to ignore short beam interruptions, such as those caused by small particles that pass through the detection area. The double-scan mode can be enabled by turning on DIP switch 4 (and cycling power). In this mode, every beam is evaluated twice (instead of once) and only beams that are interrupted during both evaluations are recognized. This allows brief beam interruptions to be ignored. The response time is increased.
