TRICONEX 9789-610 PLC備件
沒有電源順序限制
將邏輯電平跳線移動到所需位置，以設置引腳狀態或外部驅動，如邏輯電平跳線部分所述。如何使用操作：默認情況下，跳線用于控制，如所示。通過直接插入將連接到板，就像安裝了屏蔽一樣。將邏輯電平跳線設置為位置。將和跳線設置到所需位置和均為有效選項如果使用外部電源，請將其連接到炮塔；則將提供董事會。電源跳線請參閱上面的步驟必須設置為與此配置相匹配。使用電纜將插入運行應用程序的計算機。
在計算機上
打開為該板編寫的草可在解決方案，并上傳到。打開串行監視器。將通信速率設置為波特，然后選擇&。此時會顯示一個菜單，提供運行演示電路和的程序的選項，如所示?？梢酝ㄟ^鍵入并按鍵來單獨控制邏輯引腳。選擇和向施加信號。選項至控制多個引腳，將配置為指定的操作模式。所有邏輯輸入都可以在電路板左側的測試點進行監控。演示手冊零件清單項目數量參考零件描述制造商零件號所需電路組件，單總線收發器，由線性技術公司提供的信息被認為是準確可靠的。但是，對其使用不承擔任何責任。不表示其電路的互連不會侵犯現有專利權。
No power sequence restriction
Move the logic level jumper to the desired position to set the pin status or external drive, as described in the logic level jumper section. How to use the operation: By default, the jumper is used for control, as shown in. Connect to the board by inserting it directly, as if the shield was installed. Set the logic level jumper to position. Set the and jumpers to the required position and are both valid options. If an external power supply is used, please connect it to the turret; The board of directors will be provided. Refer to the steps above for the power cord. It must be set to match this configuration. Use the cable to plug into the computer where the application is running.
On the computer
Open the draft prepared for this board and upload it to the solution. Turn on the serial monitor. Set the communication rate to baud and select&. A menu will be displayed, providing the option to run the demo circuit and program, as shown in. The logic pins can be individually controlled by typing and pressing. Select and apply signals to. Options to control multiple pins will be configured to the specified operation mode. All logic inputs can be monitored at the test point on the left side of the circuit board. The number of items in the parts list of the demonstration manual refers to the description of the parts. The manufacturer's part number requires circuit components, single bus transceivers. The information provided by Linear Technology is considered accurate and reliable. However, we do not assume any responsibility for its use. It does not mean that the interconnection of its circuits will not infringe the existing patent rights.
