VMIVME-7750-466000工控機器人備件
背光控制部件
盡可能靠近 觸摸屏接口模塊集成了由控制的線觸摸屏是 總線上的從屬設備控制器發回關于和位置的信息以及施加到觸摸面板的壓力的測量值觸摸面板可以與手寫筆或手指一起使用觸摸面板控制器通過控制信號連接到接口連接兩個中斷信號并將事件信息提供給微控制器：和注意：與信號共享與信號共享因此如果與觸摸屏控制器同時使用接口請注意不要在或上同時啟用兩個驅動程序為此這些線路上安裝了歐姆電阻器以斷開任何一端驅動器與另一端驅動器的連接：在觸摸面板控制器側
連接到測試點
的觸摸輔助輸入/連接到測試點用于可選功能擴展圖觸摸面板控制 /標準針/連接器在上實現用于連接兼容的 仿真器接口例如的注：信號連接到系統按鈕也用于重置模塊可以移除歐姆電阻器以便將端口與該系統復位信號隔離當 未處于調試模式時引腳處于輸入模式上拉電阻器禁用為了避免由于浮動輸入導致 評估套件硬件開發板用戶指南 ––年月日圖接口音頻接口板支持音頻錄制和回放可使用電位計調節音頻音量并可通過跳線調節麥克風放大器增益（固定增益為或 ）
Backlight control unit
As close as possible to the touch screen interface module, the controlled line is integrated. The touch screen is the information about and the position sent back by the slave device controller on the bus and the measured value of the pressure applied to the touch panel. The touch panel can be used together with the stylus or finger. The touch panel controller connects two interrupt signals through the control signal connection to the interface and provides the event information to the microcontroller: and Note: signal sharing and signal sharing Therefore, if the interface is used with the touch screen controller at the same time, please be careful not to enable two drivers on or at the same time. Ohmic resistors are installed on these lines to disconnect the driver at either end from the driver at the other end: on the controller side of the touch panel
Connect to test point
Touch auxiliary input of/connected to the test point for optional function extension diagram Touch panel control/standard pin/connector is implemented on for connecting compatible emulator interfaces Note: the signal is connected to the system button is also used to reset the module Ohm resistor can be removed to isolate the terminal from the system reset signal When the pin is in input mode when not in debug mode Pull up resistor is disabled to avoid floating input Evaluation Kit Hardware Development Board User's Guide – – Year Month Day Chart Interface Audio interface board supports audio recording and playback You can use a potentiometer to adjust the audio volume and adjust the microphone amplifier gain through a jumper (fixed gain is or)
