WOODWARD 9907-105自動化工控模塊
計算機型號目錄
編號區域額定溫度范圍非顯示非顯示型號：限制表（U）?對于EPL Gc，工業計算機應完全安裝在防護等級最低為IP54的外殼中，并在不超過2級污染的區域使用。對于EPL Dc，要求最低防護等級為IP6x。此外，外殼還應滿足EN/IEC 60079-0:2012/2011、EN/IEC 6009-15:2010和EN/IEC 0079-31:2014/2013的適用外殼要求。?除非已知該區域無危險，否則不得使用USB端口。除非已知該區域無危險，否則不得斷開所有其他端口或連接。（2） 以下內容僅適用于ATEX和IECEx應用中的顯示器型號：安全使用特殊條件（X）?對于EPL Gc，工業計算機應安裝在外殼的墻壁中，提供最低防護等級IP54，并用于不超過2級污染的區域。對于EPL Dc，要求最低防護等級IP6x。
外殼要求
外殼還應滿足適用外殼要求。?當用戶考慮外殼內所有其他熱源的加熱時，安裝6181X-12T顯示模型的外殼的工作溫度不得超過70°C（158°F）。?除非已知該區域無危險，否則不得使用USB端口。除非已知該區域無危險，否則不得斷開所有其他端口或連接。（3） 整個非顯示計算機和顯示計算機的背面需要安裝在受限的訪問位置。安裝以下聲明適用于在危險場所使用計算機時。熱表面受限訪問位置驗證受限訪問設備的位置滿足以下條件：?只能由服務人員或已被告知限制某個位置的原因以及需要采取的預防措施的用戶進入。?訪問是通過使用工具、鎖和鑰匙，或由負責地點的機構控制的其他安全手段。警告：爆炸危險?更換部件可能會影響危險場所的適用性。
Computer Model Directory
The rated temperature range of the numbered area is non display and non display model: restriction table (U) ? For EPL Gc, the industrial computer should be completely installed in the enclosure with the lowest protection level of IP54, and used in the area with no more than level 2 pollution. For EPL Dc, the minimum protection level is required to be IP6x. In addition, the enclosure shall meet the applicable enclosure requirements of EN/IEC 60079-0:2012/2011, EN/IEC 6009-15:2010 and EN/IEC 0079-31:2014/2013. ? The USB port must not be used unless the area is known to be non hazardous. Do not disconnect all other ports or connections unless the area is known to be hazard free. (2) The following applies only to monitor models in ATEX and IECEx applications: special conditions for safe use (X) ? For EPL Gc, the industrial computer should be installed in the wall of the enclosure, with a minimum protection level of IP54, and used in areas not more than level 2 pollution. For EPL Dc, the minimum protection level IP6x is required.
Enclosure requirements
The enclosure shall also meet the applicable enclosure requirements. ? When the user considers the heating of all other heat sources in the enclosure, the operating temperature of the enclosure where the 6181X-12T display model is installed shall not exceed 70 ° C (158 ° F). ? The USB port must not be used unless the area is known to be non hazardous. Do not disconnect all other ports or connections unless the area is known to be hazard free. (3) The entire non display computer and the back of the display computer need to be installed in a restricted access location. Install the following statements for use in hazardous locations. Hot surface restricted access location Verify that the location of the restricted access device meets the following conditions: ? Only service personnel or users who have been informed of the reason for restricting a location and the precautions to be taken can enter. ? Access is through the use of tools, locks and keys, or other security means controlled by the agency responsible for the location. WARNING: EXPLOSION HAZARD ? REPLACEMENT OF COMPONENTS MAY IMPACT THE SUITABILITY IN HAZARDOUS LOCATIONS.
