DS200TCDAG1BDB數控系統模塊
準備好編程
CPU現在已準備好編程（如果并行連接，則無論鍵位置如何，都可以對CPU進行編程）。程序驗證后，撥動開關可以移動到適當的操作模式位置；啟用輸出運行、禁用輸出運行或停止。七個LED指示撥動開關的位置、內存保護狀態、串行端口活動狀態和程序狀態。編程器連接，并行對于并行接口（僅限MS-DOS編程器），編程器與總線變送器模塊（IC697BEM713）的頂部端口相連，如圖1所示。有關編程功能的說明，請參閱適用的編程軟件用戶手冊。內存保護a45723開路更換電池連接器1 MBYTE內存板CPX 782當前安裝的電池連接器內存保護鑰匙開關Y R E B A T模塊IC697CPX782標簽44A726758–152R01串行端口3在插槽1中使用此模塊，頂部遠程編程器上僅CPX 782OFF正常運行EN ON=正常，啟用，保護前運行，輸出啟用運行，輸出禁用停止鍵位置模塊功能電池連接器在拔下舊電池之前安裝新電池。
存儲器保護
使用IC697ACC701存儲器保護RS-485兼容的96 MHz 32位中央處理單元P1 P2 P3串行端口2 RS-485兼容性工廠測試串行端口1 RS-232狀態LED運行/停止開關串行端口2 RS-485串行端口1 RS-232工廠測試僅串行端口3 RS-485圖2 CPX 782-主要功能96 MHz、32位、浮點、，1 Mbyte內存中央處理單元GFK-1431F 4 PLC CPU 1999年11月系列90-70可編程控制器數據表手冊GFK-0600F 20-4 B R M a45301 IC66*塊編程器機架1機架0 P S C U B T M G B C R M IC66*總線（最大7500英尺）機架7從底部到最后一個BRM的所有互連電纜的總長度為最大50英尺。
Ready to program
The CPU is now ready for programming (if connected in parallel, the CPU can be programmed regardless of the key position). After program verification, the toggle switch can be moved to the appropriate operating mode position; Enable output run, disable output run, or stop. The seven LEDs indicate the position of the toggle switch, memory protection status, serial port activity status, and program status. The programmer is connected in parallel. For the parallel interface (MS-DOS programmer only), the programmer is connected to the top port of the bus transmitter module (IC697BEM713), as shown in Figure 1. For a description of the programming functions, refer to the applicable programming software user manual. Memory protection a45723 Open circuit Replace battery connector 1 MBYTE memory board CPX 782 Currently installed battery connector Memory protection key switch Y R E B A T module IC697CPX782 label 44A726758 – 152R01 Serial port 3 uses this module in slot 1. Only CPX 782 on the top remote programmer runs normally EN ON=normal, enable, run before protection, output enable, run, The output disable stop key position module function battery connector installs a new battery before removing the old battery.
Memory protection
Use IC697ACC701 memory to protect RS-485 compatible 96 MHz 32-bit central processing unit P1 P2 P3 serial port 2 RS-485 compatibility Factory test Serial port 1 RS-232 status LED run/stop switch Serial port 2 RS-485 serial port 1 RS-232 Factory test Serial port 3 RS-485 Figure 2 CPX 782 - Main functions 96 MHz, 32-bit, floating point, 1 Mbyte memory central processing unit GFK-1431F 4 PLC CPU November 1999 Series 90-70 Programmable Controller Data Sheet Manual GFK-0600F 20-4 B R M a45301 IC66 * block programmer rack 1 rack 0 P S C U B T M G C R M IC66 * bus (maximum 7500 feet) rack 7 The total length of all interconnecting cables from the bottom to the last BRM is a maximum of 50 feet.
