330704-000-050-10-02-05自動化模塊
環境限制工作和儲存溫度
-55°至+121°（-67°至+250°）最大沖擊存活率49050 m/s2（5000 ）。相對濕度100%冷凝，非浸沒。外殼密封。磁場敏感性<2.21 mm/s2/高斯（225 m/高斯）[50高斯，50-60z]。IP等級相當于IP 68（防塵和防水）。請注意，這僅適用于傳感器，不適用于電纜。物理重量（無電纜）99克（3.5盎司），典型直徑23毫米（0.93英寸）。高度59 mm（2.3英寸），包括安裝螺柱。連接器3針MIL--5015插座316L不銹鋼安裝表面32 min rms。安裝扭矩4.1 N·m（3.0 t·l）。外殼材料316L不銹鋼重量（無電纜）100 （3.5 oz），典型安裝角度任意方位3/9 330400和330425加速度計加速度傳感器數據表141638 Rv.Y符合性和認證本設備符合規則第15部分的要求。操作必須符合以下兩個條件：l本設備可能不會造成有害干擾。l此設備必須接受接收到的任何干擾，包括可能導致不期望操作的干擾。M M指令2014/30/歐盟RoS RoS指令2011/65/僅限歐盟海事330400和330425 S 2009鋼制船舶規則1-1-4/7.7,4-8-3/1.11.1，4-9-7/13危險區域批準有關國家和產品特定批準的詳細列表，請參閱ntly.om提供的認證快速參考指南（108M1756）。
安裝說明.
S/NRTL/ 190501（機構認證選項01至04）本質安全x i II T4：I級，iv 1，組；II級，和組；III級x i II T 4：I類，iv 2，組；II級，組III級，根據圖紙167536 T4在-40°下安裝≤ 助教≤ +100°（-40°≤ 助教≤ +212°）本質安全和非易燃x nL II T4 I級2區和組x n T4 I類2區組組根據圖紙167536 T4在-40°下安裝≤ 助教≤ +100°（-40°≤ 助教≤ +212°）330400330425 x i II T4 x i II T 4 I級，1區和組II級，和組III級T4@-40°≤ 助教≤ 100°根據圖紙167538 330500 x i II T4 x i II T 4 I級，1區，和組II級，組III級安裝按照圖紙167537 T4在-40°下安裝≤ 助教≤ 100° x nL II T4 x n II T5 I級2區組根據圖紙167537 T4在-40°下安裝≤ 助教≤ 100° 330525 x i II T4 x i II T 4 I級，1類，和組II級，組III級T4@-40°≤ 助教≤ 100° x nL II T4 x n II T5 I級2區組根據圖紙167539 T4在-40°下安裝≤ 助教≤ 100° TX/Ix 190501330400330425330500330525 190501 II 1 4/9 330400和330425加速計加速度傳感器數據表141638 Rv.Y實體參數x i II T4 II 3 x n II T4 x t III T130° T4@T=-55°至121°區域0/1區域2 Ui=30V Ui=30 V II=200 m II=200m Pi=0.75W Pi=1.14W i-27.2n Li=0 330400，330425 330500，330525實體參數II 1 x i II T4 II 3 x n II T6 x t III T130° T4@T=-55°至121° 0/1區2 Ui=28V Ui=28 V II=150 m II=150m Pi=0.84W Pi=1.26W i-10.8n Li=0危險區域安全使用條件TX/Ix 0/1區：設備必須連接到符合上述實體參數的設備。或型電纜（符合N 60079-25）必須符合實體參數中列出的電纜參數。區域2：電源電氣參數不得超過上表中提到的值。
Environmental limitations Operating and storage temperatures
-Maximum impact survival rate of 55 ° to+121 ° (- 67 ° to+250 °) 49050 m/s2 (5000). Relative humidity: 100% condensation, non immersion. Enclosure seal. Magnetic field sensitivity<2.21 mm/s2/Gauss (225 m/Gauss) [50 Gauss, 50-60z]. IP rating is equivalent to IP 68 (dustproof and waterproof). Please note that this applies only to sensors, not cables. Physical weight (without cable) 99 g (3.5 oz), typical diameter 23 mm (0.93 in). Height 59 mm (2.3 in) including mounting studs. Connector 3-pin MIL-5015 socket 316L stainless steel mounting surface 32 min rms. The installation torque is 4.1 N · m (3.0 t · l). Housing material 316L stainless steel Weight (without cable) 100 (3.5 oz), typical installation angle Any orientation 3/9 330400 and 330425 Accelerometers Accelerometers Accelerometers Accelerometers Data Sheet 141638 Rv Y Conformity and certification This equipment complies with the requirements of Part 15 of the Rules. Operation must meet the following two conditions: l This equipment may not cause harmful interference. L This equipment must accept any interference received, including interference that may cause undesired operation. M M Directive 2014/30/EU RoS RoS Directive 2011/65/EU Maritime 330400 and 330425 S 2009 Rules for Steel Ships 1-1-4/7.7, 4-8-3/1.11.1, 4-9-7/13 For a detailed list of national and product specific approvals, please refer to the Certification Quick Reference Guide (108M1756) provided by ntly.om.
Installation instructions
S/NRTL/190501 (Agency Certification Options 01 to 04) Intrinsically Safe x i II T4: Class I, iv 1, Group; Class II, and groups; Class III x i II T 4: Class I, iv 2, group; Class II, Group III, installed at - 40 ° according to drawing 167536 T4 ≤ TA ≤+100 ° (- 40 ° ≤ TA ≤+212 °) Intrinsically safe and non flammable x nL II T4 Class I, Zone 2 and Group x n T4 Class I, Zone 2 groups installed at - 40 ° according to drawing 167536 T4 ≤ TA ≤+100 ° (- 40 ° ≤ TA ≤+212 °) 330400330425 x i II T4 x i II, Class I, Zone 1 and Group II, and Group III T4@-40 °≤ TA ≤ 100 ° According to drawing 167538 330500 x i II T4 x i II T4 Class I, Zone 1, and Group II, Group III installation according to drawing 167537 T4 Installed at - 40 ° ≤ TA ≤ 100 ° x nL II T4 x n II T5 Class I, Zone 2 group installed at - 40 ° according to drawing 167537 T4 ≤ TA ≤ 100 ° 330525 x i II T4 x i II T4 Class I, Class 1, and Group II, Group III T4@-40 ° ≤ TAs ≤ 100 ° x nL II T4 x n II T5 Class I 2-block installation at - 40 ° according to drawing 167539 T4 ≤ TAs ≤ 100 ° TX/Ix 19050133040033042533000330525 190501 II 1 4/9 330400 and 330425 accelerometer accelerometer data sheet 141638 Rv Y entity parameter x i II T4 II 3 x n II T4 x t III T130 ° T4@T =-55 ° to 121 ° Zone 0/1 Zone 2 Ui=30V Ui=30 V II=200 m II=200m Pi=0.75W Pi=1.14W i-27.2n Li=0 330400330425 330500330525 Entity parameter II 1 x i II T4 II 3 x n II T6 x t III T130 ° T4@T =-Zone 0/1 from 55 ° to 121 ° 2 Ui=28V Ui=28 V II=150 m II=150 m Pi=0.84W Pi=1.26W i-10.8n Li=0 Conditions for safe use in hazardous areas TX/Ix Zone 0/1: the equipment must be connected to the equipment meeting the above physical parameters. Or type cable (conforming to N 60079-25) must conform to the cable parameters listed in the physical parameters. Zone 2: The electrical parameters of the power supply shall not exceed the values mentioned in the above table.
