產品細節介紹
COLMAN 41AA-23003-212-3-00控制器
程序員版本要求
? 必須使用Proficy Machine Edition Logic Developer 5.8或更高版本執行EGD交換和冗余傳輸列表的運行模式存儲。
? Proficy Machine Edition Logic Developer 5.7或更高版本必須用于5.00版的新功能
? Proficy Machine Edition Logic Developer 5.5 Service Pack 2或更高版本必須用于4.00版的新功能。
? Proficy Machine Edition Logic Developer 5.0 Service Pack 3或更高版本必須
用于為Modbus/TCP服務器操作的CPU編程。
SRTP和EGD性能與90-70系列不同
RX7i中的SRTP和EGD性能與90-70系列略有不同。
每個RX7i以太網接口支持更多SRTP連接和EGD交換。
還請注意，RX7i目前有幾個SRTP和EGD運行與Series 90-70相比的限制。遷移Series 90.70時RX7i的以太網應用程序，請仔細閱讀“以太網操作注釋”第18頁。
Series 90-70 LAN接口模塊（IC697CMM741和IC697CMM742）不受支持通過RX7i
請注意，Series 90-70 LAN接口模塊（IC697CMM741和IC697CMM742）不受RX7i支持，不應放置在RX7i機架。RX7i CPU包含嵌入式以太網接口。
如果附加需要以太網接口，RX7i以太網模塊（IC698ETM001）應該使用。
CIMPLICITY*工廠版
版本要求CIMPLICITY Plant Edition 6.1 Service Pack 1a，帶更新040204_s90tcp_6101或Service Pack 2或更高版本必須用于與PAC系統。
控制器消耗EGD數據UDP校驗和錯誤客戶報告PLC正在使用UDP錯誤的EGD數據校驗和。
在早期版本中，當加速模式設置為ON（默認）時，未驗證UDP校驗和以減少過載。
以太網固件6.20實現了一種允許計算校驗和的方法當加速模式設置為ON而不影響性能時。
控制器沒有響應TOS/QOS已配置客戶報告，當配置TOS/QOS位時控制器沒有響應。
固件已更正為繼續當其他設備使用TOS/QOS位時進行通信。回應幀將TOS/QOS位設置為0。
SRTP通信問題當快速打開和關閉多個連接時，以太網接口可能進入阻止遠程客戶端連接的狀態使用SRTP通信。這已在以太網固件中糾正版本6.20。
Programmer Version Requirements
? Proficy Machine Edition Logic Developer 5.8 or later must be used to perform Run-mode Store of EGD exchanges and Redundancy Transfer Lists. ? Proficy Machine Edition Logic Developer 5.7 or later must be used for Release 5.00 new features ? Proficy Machine Edition Logic Developer 5.5 Service Pack 2 or later must be used for Release 4.00 new features. ? Proficy Machine Edition Logic Developer 5.0 Service Pack 3 or later must be used to program the CPU for Modbus/TCP Server operation. SRTP and EGD Performance Differs from Series 90-70 SRTP and EGD performance in the RX7i differs slightly from the Series 90-70. Each RX7i Ethernet Interface supports a greater number of SRTP connections and EGD exchanges. Please also note that the RX7i currently has several SRTP and EGD operational restrictions when compared to the Series 90-70. When migrating Series 90-70 Ethernet applications to the RX7i, please carefully read the "Ethernet Operational Notes” section on page 18. Series 90-70 LAN Interface Modules (IC697CMM741 and IC697CMM742) not supported by RX7i Please note that the Series 90-70 LAN Interface Modules (IC697CMM741 and IC697CMM742) are not supported by the RX7i and should not be placed in an RX7i rack. The RX7i CPU contains an embedded Ethernet Interface. If additional Ethernet Interfaces are required, the RX7i Ethernet Module (IC698ETM001) should be used. CIMPLICITY* Plant Edition Version Requirements CIMPLICITY Plant Edition 6.1 Service Pack 1a with Update 040204_s90tcp_6101 or Service Pack 2 or later must be used for Ethernet communications with PACSystems.
Controller consumed EGD data with bad UDP checksum
Customer reported that the PLC is consuming EGD data with bad UDP checksum. In previous releases, while acceleration mode is set to ON (default), the UDP checksum was not validated to reduce the overload. Ethernet firmware 6.20 implements a method that allows checksums to be calculated when acceleration mode is set to ON without impacting performance. Controller did not respond when TOS/QOS were configured Customers reported that when TOS/QOS bits are configured, then the Controller does not respond. The firmware has been corrected to continue to communicate when TOS/QOS bits are used by other devices. The response frame will set the TOS/QOS bit to 0. SRTP communication issue When multiple connections were opened and closed very quickly, the Ethernet interface could enter a state that prevented remote clients from connecting using SRTP communications. This has been corrected in Ethernet firmware version 6.20.
公司主營產品圖展示
產品優勢
1：國外專業的供貨渠道，具有價格優勢
2：產品質量保證，讓您售后無憂
3：全國快遞包郵
4：一對一服務
公司主營范圍簡介
PLC可編程控制器模塊，DCS卡件，ESD系統卡件，振動監測系統卡件，汽輪機控制系統模塊，燃氣發電機備件等，優勢品牌：Allen Bradley、BentlyNevada、ABB、Emerson Ovation、Honeywell DCS、Rockwell ICS Triplex、FOXBORO、Schneider PLC、GE Fanuc、Motorola、HIMA、TRICONEX、Prosoft等各種進口工業零部件、歐美進口模塊。
產品廣泛應用于冶金、石油天然氣、玻璃制造業、鋁業、石油化工、煤礦、造紙印刷、紡織印染、機械、電子制造、汽車制造、塑膠機械、電力、水利、水處理/環保、鍋爐供暖、能源、輸配電等等
