IS200SAMBH1ABA燃機卡件,GE使用說明
鋰電池包含易燃材料例如鋰和有機溶劑。中頻鋰電池如果受到虐待或處理不當，它們可能會爆裂打開并點燃，可能導致受傷和/或火災。處理鋰電池時，請仔細遵循以下列出的預防措施，以防止發生事故。
? 不要短路。
? 不要拆卸、變形或施加過大壓力。
? 不要加熱或焚燒。
? 不要直接使用焊料。
? 不要使用不同的型號。
? 不要充電。
? 始終檢查正確的極性。
IS200SAMBH1ABA燃機卡件要從模塊中卸下電池，請小心拉動電池從插座。（如果未安裝新電池，數據將丟失30秒內。）
安裝新電池之前，請確保電池針腳正確清潔的記下電池極性并將電池壓入插座車載DRAMMVME187板載DRAM位于夾層板上。夾層板有不同的尺寸和尺寸奇偶校驗保護或ECC保護。注：奇偶校驗夾層僅在25 MHz主設備上受支持董事會。摩托羅拉軟件確實支持混合奇偶校驗和ECC內存同一主板上的板。DRAM是四路交錯的，以有效支持緩存突發循環。機載DRAM夾層有以下配置：? 4、8、16或32MB，具有奇偶校驗保護
? 4、8、16、32、64或128 MB，帶ECC保護堆疊夾層可以堆疊兩塊夾層板，以提供高達256MB的車載RAM（ECC）。
? MVME187板和單個夾層板在一起拿一個槽。
? 堆疊配置需要兩個VMEboard插槽。
time of this cycle is the largest. The program must be simple and practical, so as to minimize the execution cycle and reduce the time delay of control. From a macro point of view, the scanning cycle shows the characteristics of scalability.
5 Conclusion
According to the functional requirements of mobile robot under slurry and the characteristics of PLC, the control network of mobile robot under slurry has characteristics, realizes the communication between networks, discusses the motor control method, so that the motor can run continuously and stably, and finally designs the software program of the whole control system. The work involved in this paper has been debugged successfully. The washing bucket (outer bucket) and dewatering bucket (inner bucket) of the full-automatic washing machine are placed in the same center. The outer barrel is fixed for holding water; The inner barrel can be rotated for dehydration (drying). There are many small holes around the inner barrel to connect the water flow between the inner barrel and the outer barrel. The water inlet and drainage of the washing machine are performed by the water inlet solenoid valve and the drainage solenoid valve respectively. When water enters, open the water inlet solenoid valve through the control system and inject water into the outer barrel through the water inlet pipe. When draining water, open the drain electronic valve through the control system to drain the water from the outer barrel to the outside of the machine. The washing forward and reverse rotation is realized by the forward and reverse rotation of the wave plate driven by the washing motor. At this time, the dewatering bucket does not rotate. During dehydration, the control system closes the clutch and the washing motor drives the inner barrel to rotate forward for drying. High and low water level control switches are used to detect high and low water levels respectively.
