P0917TQ輸出個性模塊,FBM215配置教程
維護過程所需的工具和設備包括：
?抗靜電真空。
?四英寸一字螺絲刀（適用于任意端接裝置端子或終端模塊端子）。
?異丙醇（99.5%電子級）。
?Eberhard Faber（400A）粉色珍珠橡皮擦。
?玻璃纖維拋光刷。
?無絨布。
?功能代碼應用手冊。?小尖嘴鉗。
P0917TQ輸出個性模塊預防性維護程序本節涵蓋了表7-1中需要特定說明或進一步解釋：
?檢查信號、電源和接地連接。
?清潔印刷電路板和邊緣連接器。
?校準LVDT變壓器和液壓執行器檢查所有信號接線、電源和接地連接HSS模塊及其相關終端單元或模塊。檢查連接時，務必轉動螺釘、螺母或其他僅按擰緊方向緊固裝置。如果連接松動，將擰緊。如果連接緊密，則擰緊操作將驗證其是否牢固。絕對不能有任何松開連接的動作。
The tools and equipment required for the maintenance procedures include:
? Antistatic vacuum.
? Four-inch flat screwdriver (suitable for either termination
unit terminals or termination module terminals).
? Isopropyl alcohol (99.5 percent electronic grade).
? Eberhard Faber (400A) pink pearl eraser.
? Fiberglass burnishing brush.
? Lint free cloths.
? Function Code Application Manual. ? Small needle nose pliers.
PREVENTIVE MAINTENANCE PROCEDURES
This section covers tasks from Table 7-1 that require specific
instructions or further explanation:
? Checking signal, power and ground connections.
? Cleaning printed circuit boards and edge connectors.
? Calibrating the LVDT transformer and hydraulic actuatorCheck all signal wiring, power and ground connections for the
HSS module and its associated termination unit or module.
When checking connections, always turn a screw, nut or other
fastening device in the direction to tighten only. If the connection is loose, it will be tightened. If the connection is tight, the
tightening action will verify that it is secure. There must not be
any motion done to loosen the connection.
