MVME6100工控卡件,PLC模塊MVME6100
創建CIP通用消息以傳輸DPV1命令在RSLogix 5000軟件中：
您的MSG（緩存連接）指令數量有限
可以在RSLogix 5000中保持打開（緩存）狀態。查看聯機幫助以找出局限性。
如果在梯形圖邏輯中使用的MSG指令超過16條，建議您禁用消息指令的緩存選項。
對于只需執行一次的消息指令（即DPV1 Init和DPV1 Class 2 Init命令）禁用緩存連接是建議您運行更多緩存連接消息。
MVME6100工控卡件1、從輸入/輸出選項卡中選擇消息指令，并將其放入配置工具概述的梯級中
SST PROFIBUS配置工具可以通過以太網與SST-PB3-CLX-RLL掃描儀。
必須使用以下產品版本：
?固件版本7.27或更高版本
?配置工具版本3.12.1.0或更高版本
?RSLinx驅動程序版本2.2 OEM/Professional或更高版本請參閱第A.1節，安裝和配置RSLinx驅動程序，有關配置驅動程序的詳細信息。
圖18：掃描儀、以太網和配置工具的關系
梯形圖代碼。
Creating a CIP Generic Message for Transmitting a
DPV1 Command
In the RSLogix 5000 software:
Note
There is limit to the number of MSG (cache connection) instructions you
can leave as opened (cached) in RSLogix 5000. Check the online help to
find the limitations.
If you are using more than 16 MSG instructions in your ladder logic,
we recommend that you disable the cache option for MSG instructions.
For MSG instructions that only have to be executed once (i.e., DPV1 Init
and DPV1 Class 2 Init commands) disabling the cache connection is
recommended so that you can run more cache connection messages.
1. Select the MSG instruction from the Input/Output tab and place it into a rung of Configuration Tool Overview
Through Ethernet, the SST PROFIBUS Configuration Tool can communicate with an
SST-PB3-CLX-RLL scanner.
Note
The following product versions must be used:
? Firmware version 7.27 or higher
? Configuration Tool version 3.12.1.0 or higher
? RSLinx driver version 2.2 OEM/Professional or higher
Note
Refer to Section A.1, Installing and Configuring the RSLinx Driver,
for details on configuring the driver.
Figure 18: Scanner, Ethernet and Configuration Tool Relationship
ladder code
