DEIF PCD2.M110模塊,PCD2.M110使用配置手冊
信號調節
傳感器信號輸出前插座SMB和/或z14/z16*，未耦合，防斷路和短路，無反應。
通道1? 傳感器1 SMB K1
通道2? 傳感器2 SMB K2
信號輸出?1.?24 V；信號1:1至傳感器輸入信號精度為f.s.d的±1%。
DEIF PCD2.M110模塊頻率范圍0。。。16千赫(?3 dB）±20%每負載電阻>100 kΩ內阻1 kΩ*取決于跳線設置J2。
動態輸出傳感器信號的交流部分作為縮放值輸出。
通道1? AC1/通道2? AC2 z14/z16*打開?電路和短路?防電路，非?反應性
標稱范圍0。。。20 Vpp
測量范圍與配置的測量范圍相對應特征值，最小400 mVpp，最大8000 mVpp精度為f.s.d的±1%。
DEIF PCD2.M110模塊頻率范圍0.1 Hz。。。16千赫(?3 dB）±20%每負載電阻>10 kΩ電源阻抗10 kΩ內阻約為20Ω*取決于跳線設置J2。
按比例的直流輸出傳感器信號的直流部分（與靜態距離傳感器/測量值成比例對象）輸出為標準直流電壓NGL。
通道1? NGL1/通道2? NGL2 z12/d12斷路和短路保護，非反應性標稱范圍0+10 V直流電測量范圍根據傳感器0 V對應于工作范圍的較低值+10 V對應于功的上限值范圍精度/分辨率±1%f.s.d./12位每負載電阻>10 kΩ內阻約為50Ω
Signal conditioning
Sensor signal outputs Front sockets SMB and/or z14 / z16*, uncoupled,
open circuit and short circuit proof, non reactive.
Channel 1 ? SENS 1 SMB K1
Channel 2 ? SENS 2 SMB K2
Signal output
?1 ... ?24 V; signal 1:1 to sensor input signal
Precision
±1 % of f.s.d.
Frequency range 0 ... 16 kHz (?3 dB) ±20 %
Per. load resistance > 100 kΩ
Internal resistance 1 kΩ
*Depends on the jumper setting J2.
Dynamic outputs
The AC portion of the sensor signal is output as scaled value.
Channel 1 ? AC1 / channel 2 ? AC2 z14 / z16* open?circuit and short?circuit proof, non?
reactive
Nominal range 0...20 Vpp
Measuring range Corresponds to the measuring range configured for
the characteristic value, min. 400 mVpp,
max. 8000 mVpp
Precision
±1 % of f.s.d.
Frequency range 0.1 Hz ... 16 kHz (?3 dB) ±20 %
Per. load resistance > 10 kΩ
Source impedance 10 kΩ
Internal resistance Approximately 20 Ω
*Depends on the jumper setting J2.
Scaled d.c. Outputs
The DC portion of the sensor signal (proportional to the static distance sensor / measurement
object) is output as standardized DC voltage NGL.
Channel 1 ? NGL1 / channel 2 ? NGL2 z12 / d12 open circuit and short circuit proof, non
reactive
Nominal range 0 ... +10 V DC
Measuring range According to the configured operating range of the
sensor
0 V corresponds to the lower value of the work range
+10 V corresponds to the upper value of the work
range
Precision / resolution
±1 % of f.s.d. / 12 Bit
Per. load resistance > 10 kΩ
Internal resistance Approximately 50 Ω
